Pyramid DC Receiver Manual de instalación descargar pdf (Pagina 4)

Page 4

Pyramid DC Receiver Installation Manual

PRODUCT SAFETY

WARNING

 Please follow these instructions as you install the equipment and keep them for future use.

 Installation is only to be carried out by competent, qualified and experienced personnel in accordance with the

country of installations National Wiring Regulations. Failure to do so can result in injury or death by electric shock.

 Use a class 2 isolated power supply for the 12V DC.

 The module is susceptible to damage from Electrostatic Discharge (ESD). Take normal ESD precautions when

handling your network card. ESD prevention kits are available from most electronics distributors.

 Do not exceed the voltage and temperature limits given in the specification.

 Switch off the power before fitting a network card.

 If you have any problems, contact Baxall Limited.

ELECTROMAGNETIC COMPATIBILITY (EMC)

CAUTION

 This is a Class A product. In a domestic environment this product may cause radio interference in which case the

user may be required to take adequate measures.

 This product is intended for use in general purpose CCTV applications in a residential, commercial or light

industrial EMC environment. Refer to Baxall Limited before using the product in medical and/or intrinsically safe

applications or in an industrial EMC environment.

 If you are using the PCB version of this product in a way other than correctly installed in the Pyramid system

weatherproof boxes, then it is your responsibility to meet EMC requirements.

 The product must be installed in accordance with good installation practice for EMC to enable the product to

function as intended and to prevent EMC problems.

 Contact Baxall Technical Support to obtain a specification defining the acceptable levels of product degradation

with regard to EMC immunity.

MANUFACTURERS DECLARATION OF CONFORMANCE

CAUTION

The declaration of conformance applies only to the boxed version and PCBs which are correctly installed in our

Pyramid system weatherproof box.

The manufacturer declares that the equipment supplied with this manual is compliant with the essential protection

requirements of the EMC directive 89/336 and the Low Voltage Directive LVD 73/23 EEC. Conforming to the requirements

of standards EN55022 for emissions, IEC801 parts 2, 3 and 4 for immunity and EN60950 for Electrical Equipment safety.

UNPACKING

Keep your packaging for use if your DC receiver is stored for an extended period or needs to be returned for any reason.

The packaging should contain:-

 A DC Receiver

 An A4 Module Description Sheet (for installation details)

 These instructions

 Two identical barcodes

Check the product code on the serial number label. If you have an incorrect item or it is damaged then inform the

suppliers and carriers immediately. If this is the case, do not attempt to use the equipment.

BARCODING

The DC receiver is supplied with two identical barcodes. Remove one and affix it to the module description sheet, remove

the other and affix it to the module.

The barcode gives the unique 48-bit neuron ID to the module. This neuron ID is also stored inside the module and will

be transmitted onto the network whenever the PCB service pin is pressed. Before installation, make a careful note on

your module description sheet of all your installation details and the proposed location of the module. Then during

subsequent installation using the Windows installation tool the neuron ID can be entered.

We recommend that during a system installation you store the module description sheets in a ring-bound file, and keep

them for reference after the installation is complete.

1 2 3 4 5 6 7 8 9 ... 19 20

Comentarios a estos manuales

Sin comentarios

Pyramid DC Receiver Manual de instalación Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Pyramid DC Receiver