Pyramid DC Receiver Manual de instalación descargar pdf (Pagina 13)

Page 13

Installation Manual Pyramid Universal Dome Interface

CONNECTING A DENNARD DOME CAMERA

Dennard dome cameras are supplied with a flying lead connector which is connected to the socket on the top of the

dome housing. The flying lead connector is a multicore cable, and two of the wires are used specifically for network

connections. To connect these wires to the UDI, follow the steps below:

CAUTION

When connecting the UDI to a dome, reference should also be made to documentation provided with the dome.

1. Connect the yellow and green wires on the multicore cable to the UDIs Dome Data Connector. The green wire

should be connected to the - terminal and the yellow wire to the + terminal as shown below:

DOME DATA

DENNARD DOME MULTICORE CABL

YELLOW WIRE

GREEN WIRE

Connecting a Dennard Dome to the UDI

2. To address the dome camera it is necessary to remove the protective parts of the dome. First, carefully remove the

retaining screws and lift away the outer hemisphere.

3. Locate the two fixing screws and remove the inner shroud. The dome address switches should now be clearly

visible on the lower PCB.

4. Using the switches, set the dome address to 1. To do this, set both the blue switch and the yellow switch to the 0

position.

5. Refit the inner shroud and outer hemisphere, taking care to tighten the fixing screws.

CONNECTING A PANASONIC DOME CAMERA

Panasonic dome cameras are fitted with a multiple connector lead. There are five connectors on the lead, and each

connector is used for a different purpose (i.e., alarms, power, video, data). The wires from the UDIs Dome Data

Connector are connected to the dome using the data connector of this lead. To make this connection, follow the steps

below:

CAUTION

When connecting the UDI to a dome, reference should also be made to documentation provided with the dome.

1. Wire a female data connector with the wires from the UDIs Dome Data Connector as shown below. The pre-wired

male connector from the dome can then be inserted into the female connector to provide the data path between

dome and UDI.

RED

BROWN

ORANGE

YELLOW

GREEN

T (B)

GND

T (A)

R (B)

R (A)

DATA

RANSMISSION

DATA

RECEPTION

PRE-WIRED PANASONIC

DATA CONNECTOR

FEMALE

CONNECTOR

FROM + TERMINAL

FROM - TERMINAL

WIRES FROM DOME DAT

CONNECTOR ON UDI:

Connecting a Panasonic Dome to the UDI

2. On the top of the dome camera, there is a block of eight dip switches labelled SW1. Use these switches to set the

dome address to 1. To do this, move the switch labelled 8 into the ON position and ensure that the other switches

are set to OFF.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comentarios a estos manuales

Sin comentarios

Pyramid DC Receiver Manual de instalación Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Pyramid DC Receiver